This build is primarily focused on getting the most “enterprise” server like build we can and top tier performance. The heavy focus here will be on the motherboard because that is what is going to enable us to have loads of features that people would enjoy from a older/used Dell, SuperMicro, HP, Intel, or other brands of server manufactures.

I used the AC Infinity Airframe to bring down my server closet temperatures because the room was always sitting around 90°F or more. This installation is what worked for my specific situation which you may be able to adapt in your home. You could also do this for an Audio/Video Closet or Network Closet.

Let’s fix “ Sorry, an error occurred in processing your SSL certificate. The error is: Your router or DNS server has DNS rebinding protection enabled, preventing alkdfjhh20u9eewljlns.unraid.net 192.168.1.8 resolution. “

We are once again performing a simple test to observe some potential performance differences in different array configurations. This time I will include the NVMe results as well. There are truly some interesting results here.

I recently just shucked the new revised version of the WD 12TB easystore and as far as I can tell it is a helium filled drive and runs at 5400 RPM, which will make a for a great addition to my Unraid NAS array. It also most likely has a 512MB cache but I have yet to verify this.

In this guide we will backing up Unraid to another Unraid server using rsync. While the steps to make this happen may seem daunting, they are actually very simple and mostly painless! Let’s bash our brains!

This is a very simple test where we are looking to see if using NVMe in parity will have any major improvement over hard drives in parity. Spoiler, between the two different NVMe drives I tested with, there was no major improvements in write speeds.

This is a very simple examination/case study of what may happen if you use all NVME drives in an Unraid Array. Mmmm, data is beautiful. There is so much that needs to be stated before just jumping into the charts and results, so let’s get moving!

This is going to cover a wide range of information and even a little bit of my personal experience with AT&T and how it compares with Google Fiber. This one is going to be long, so I guess let’s go ahead and get started. You may be interested in reading about Google Fiber before reading this as there is some overlap between the two.

This post is deprecated, please use the new link. Updated 3/20/2021

It turns out, in the greatest stroke of luck, I was able to install 128GB’s of RAM in my Ryzen Server. The strangest part about this is, Asus says that the Crosshair VI only supports up to 64GB’s of RAM, so what gives? Let’s take a look at how this all went down.

This is a guide to make a Unraid a game re-streaming server, so you can stream to Twitch, Mixer, YouTube, etc. In this example we will only be configuring our container to stream to Twitch. Let’s take a look!

The need to migrate Unraid to new low powered hardware has finally arisen. We will be migrating from Dual Xeon LGA 2011 2960’s to a Ryzen 3700x for the homelab. This is going to be so much fun! This is the Ryzen Unraid server build I have been waiting for!

<Solved> The infamous, Streaming Error - “Could not access the specified channel or stream key. Please log out and back in to refresh your credentials. If the problem persists, there may be a problem connecting to the server.” At the time of writing there does not seem to be a fix for this error and the 10GbE Aquantia AQtion NIC.

Finally Gigabit internet for the home lab. I can now fully flex my Ubiquiti equipment and so, now the fun begins!

The Dell T30 is pretty close to perfect for a home server using Unraid and OpenVPN, especially for $299.

Previously, we were using a peer-to-peer setup to achieve 10Gig transfers. Now, we have added a UniFi US-16-XG 10Gb Switch into the mix so that more clients can now take advantage of the extra available bandwidth. It’s been an entire year since we last tried to achieve 10Gig speeds and now we are finally here. Let’s take a dive into the entirety of the setup.

Bifurcation, 4xNVME Drives, Unraid, what more could a man ask for!?!?

Updated for 2020! Quiet down that noisy Dell PowerEdge server using IPMI! We also can now use impi in Unraid through a Docker Container called Nerdpack. Let’s check this out!

Picked this up from a local recycle center for $50 bucks. Not a bad deal at all considering it is a 1TB NVMe. Didn’t really know what to expect since benchmarks were a bit varied. So here is what I scored.